mike | Shared With: Everyone - May 03 2008 | business cards, design, metalTechnical requirements for etching a metal business card. Summary:
- Cut outs OK
- Shapes that are smaller than a standard biz card OK.
- Avoid sharp corners (safety!)
- Avoid etching the edges (safety!)
- Front AND back etching at no extra cost (but should not overlap - or the etch will go all the way through).ShareViewed: 3 Times
- royleban - May 04 2008
You must be Mike's friend before you can comment on this Fave.Yup, I'm pretty sure this is where Woz gets his cards.
Send Mike a friend request or a personal message instead.